logo

4L60E Transmission Rebuild Page 31 of 33

 
Figure 110
Figure 110
Figure 111
Figure 111

Figure 110 and 111. Install the bracket on the case. Install the 5/16-24 holding screws, leave them loose for now.

Figure 113
Figure 113
Figure 112
Figure 112

Figure 112. Tighten up all the bracket screws. Tighten the side holding screws until the bracket moves out approximately 1/8th inch on each side. Install a jam nut on each holding screw. Install the set screws in the top of the bracket to support the plate againse the transmission case.

Figure 113. Install the shifter on the plate in the position you need it. If it is farther back than the two side plates, there are screws supplied for it. If it installs where the bolts for the side plates are, take the side plate bolts out, place the shifter on the plate, and re-install the bolts.


 
 
© 2017