Figure 41. There is now another torrington bearing to install. Dunk it in transmission fluid and install it inside the reaction carrier.
Figure 42. Dunk the front planetary in transmission fluid and install it in the reaction sun gear.
Figure 43. Now place the new output shaft into the transmission from the back end through the planetaries. Tap it lightly with a rubber mallet and make sure it is seated in far enough to get the snap ring on. You will need the horseshoe pliers to get this retaining ring on.
Figure 44. This is what the new output shaft looks like when it is installed in the transmission.
Pages: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 23, 24, 25, 26, 27, 28, 29 |
<--Previous | 4L60E Rebuild Home | Next--> |
Contact: Copperhead | As an Amazon Associate I earn from qualifying purchases | © 2019 |